![]() They seem to like a hard packed moist track. The Vite tires worked like they should and got no further damage. Well with everything that happened I think all went as good as it could. ![]() ![]() This event is what I needed to shake down the truck and tires. The pull off was as bad as my first pull after they loaded up the sled. #RC TRACTOR PULLS FOR SALE FULL#My third pull was much better I got my full pull and into the pull off. It was do or die on my third pull since I needed a full pull to get into the pull off. My second pull wasn’t much better so we got real drastic on the setup. This tire was biting the track so hard it was killing the engine. (I also ordered sprockets.) We tried to reduce the down force on the rear Vite tires to get it to spin more. We immediately knew that we needed a gear change but of course I didn’t have one so it was plan B. When we tested at the farm everything went grate as far as the tires and gearing but it was not as good a track it was soft. Now rembering this is a new truck and a new tire. ![]() My first pull was way short and the engine started to nose dive about half track or so but it was running fine after the pull. The NRCTPA track was hard packed and moist. (I ordered a brand new chainsaw and a K&N filter to replace it.) The only problem with the switch was dads was a 33cc and mine was 38cc. So we had it running by the time pulling started even with a trip to the hardware store for a tool I didn’t have with me. That was lucky for me now I had an engine. Dad built a tractor to sell and brought it to the event. So here I stand with a junk engine just before the pulling starts 225 miles from home. Somehow the filter failed and dirt got in it bad when we pulled at the farm. Then about 45 minuets before the pulling was to start we went outside to start and tune my truck and it wouldn’t run right then just locked up. I got a late start Saturday morning and missed the concourse. The glue worked grate no new damage after 4 pulls at the springs. There were lots of small tares that I didn’t see before. So I spent about two hours going over the damaged tire and gluing all the damage with tire glue. The weekend started by not receiving the shipment of Vite tires. Hi guys now I can take some time and let you know how the spring event went for me. #RC TRACTOR PULLS FOR SALE FREE#Please feel free to ask questions if you like. #RC TRACTOR PULLS FOR SALE PRO#I would be interested to hear comments pro or con. I am going to try to post a photo of the pair I have. Height of rubber ridge 3.5 mm 0.1379 inch I will be at the NRCTPA springs in May and may have the whole line of tires he has by then. I have not been able to test them yet so I am just telling you what I was told.Īt this point in time I have one pair to test and show around. They are grate for most dirt pulling tracks. They don’t fit standard RC wheels so they come with nice aluminum wheels.įrom what I have been told these are not for concrete, pavement or real hard surfaces. They are a solid tire so no more cutting and stuffing foam. Over the whole tire there is a solid tip of 2mm PU ( Poly Eurethaan)the rest of the tire exists of compact foam. They are also made quite a bit different than the normal RC tire. These are the badest looking tires I have ever seen for RC pulling. ![]() Hi guys I have been working with Harry from Vite Traction to bring a new pulling tire to the USA.I am going to be the USA dealer for these grate tires. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |